91
General Questions / Re: USB3 storage not seen after reboot
« on: January 05, 2017, 11:51:52 PM »
Dear Team,
If usb 3.0 power takes from Sparky , it will works always properly.Some of the external powered hub behaves detection issue due to its power sequence /reset properties.
run below commands for unbind and bind.
echo -n xhci-hcd.0.auto | tee /sys/bus/platform/drivers/xhci-hcd/unbind
echo -n xhci-hcd.0.auto | tee /sys/bus/platform/drivers/xhci-hcd/bind
With Regards
Sparky Admin
If usb 3.0 power takes from Sparky , it will works always properly.Some of the external powered hub behaves detection issue due to its power sequence /reset properties.
run below commands for unbind and bind.
echo -n xhci-hcd.0.auto | tee /sys/bus/platform/drivers/xhci-hcd/unbind
echo -n xhci-hcd.0.auto | tee /sys/bus/platform/drivers/xhci-hcd/bind
With Regards
Sparky Admin