SPARKY FORUM

Recent Posts

Pages: 1 2 [3] 4 5 ... 10
21
Technical Questions / Re: Battery connection
« Last post by sparkyadmin on May 16, 2017, 10:27:20 PM »
Dear Ayyappan,

   3.7 volt and 3500mAH

With Regards
Sparky Admin
22
Technical Questions / Battery connection
« Last post by Ayyappan on May 16, 2017, 09:30:08 PM »
What is the battery voltage and Amphere needed to start and work the allo sparky
23
Technical Questions / Re: Telecom pinout and IR LEd
« Last post by sparkyadmin on May 10, 2017, 08:47:22 PM »
Hi,

  Please find the below link for 50 pin telecom connection details

http://61.12.17.162:9098/sparky/50-pin-connection-details.pdf

With Regards
Allo Support
24
KALI RECLOCKER / Howto get mute signal from reclocker board to mute DAC chip ?
« Last post by hifiman on May 10, 2017, 02:24:24 PM »
Hi,

Is there a signal from the Kali reclocker board that I can use to connect to the mute pin of my dac chip in order to avoid cracks in between tracks/albums?

Thanks.

Ronald
25
Technical Questions / Telecom pinout and IR LEd
« Last post by pbreizh on May 10, 2017, 06:14:38 AM »
Hello

I would like to use the telecom port to connect an HS0038 module and use LIRC with it.
Where can I find the 50 pin Telecom Pinout details and is there GPIO Pin from (40 pin RPI like) avaiblable on the 50 pin telecom?

Best regards
26
KALI RECLOCKER / Loud digital crack when switching between albums
« Last post by hifiman on May 09, 2017, 01:42:52 AM »
I am happy with my Allo Kali board, it's working well and sounding good :-)

However I do have one issue, when switching between albums there is this loud digital crack, which I am afraid might damage my expensive tweeters. It does not happen when skipping to the next track within the same album. Can this be an issue of the Allo Kali board? It does not seem to happen on a second (simpler) streamer I made using Pi/hifiberry DAC.

I am using picoreplayer (squeezelite and LMS). And the I2S output of the Allo Kali board is connected to a AK4396 DAC chip with short leads (< 6 cm).



27
Technical Questions / Re: eMMC Card reader
« Last post by sparkyadmin on May 07, 2017, 11:27:29 PM »
Dear Ayyappan,

    You can purchase odroid  card reader for for eMMC card.

With Regards
Allo Support
28
Technical Questions / eMMC Card reader
« Last post by Ayyappan on May 07, 2017, 11:04:35 PM »
Where do i get the eMMC Card reader pcb.
For the eMMC card to install os
29
Technical Questions / Installation process
« Last post by Ayyappan on May 07, 2017, 11:02:54 PM »
Hi

Whether the allo sparky board can support the java package of JDK 1.8 version(java 1.8v) 
30
Dear Anand,

    Please do the setting as shown in below link.

http://61.12.17.162:9098/sparky/OSMC.jpg

With Regards
Allo Support
Pages: 1 2 [3] 4 5 ... 10